|
Step by Step Instructions
|
 |
Step 1
Measure the room and draw a sketch to help you calculate which DEVI package you will need. Then sketch in the position of the devimat heating cable mat. |
 |
Step 2
Mark the positioning of the toilet before you remove it. This helps you avoid placing the toilet on top of the mat - and prevents you from piercing it with screws. |
 |
Step 3
Cut a channel approx. 10 mm deep and wide in the wall and the floor, from the thermostat and about 1 m out into the floor. Glue the flex pipe for the sensor into this channel, and seal the end of the pipe with a piece of tape. |
 |
Step 4
Clean the floor thoroughly, removing all dirt and soap residue, then lay out the self-adhesive cable mat. The floor surface must be primed if you are not laying the mat on existing tiles. |
 |
Step 5
Clip through the grey netting to turn the mat over - but make sure that you do not cut through the red cable! |
 |
Step 6
Turn the mat and position it as required. The self-adhesive effect can withstand 10-20 adjustments, so you can move the mat several times until you are satisfied with the result. |
 |
Step 7
Once you have positioned the cable mat, you can - depending on the new floor surface - encapsulate it using selflevelling screed or cover it with a thin layer of tile adhesive. |
.jpg)
